Quick Start Guide

ManualsBrandsDeister Electronic ManualsElectronicsPersonal Tag Transponder

For more information and your nearest point of contact, please refer to www.amantag.com Technical data are subject to change without notice at any time. The product

psa-3_manual_en_896383_v200421_.docx

PSA 3 tag quick start guide

Also applies:

ITA3

1 Package contents

 amanTag PSA 3 tag

 Quick start guide

2 Tag installation

The tag must be installed by a trained amanTag system administrator. The tag will be automatically added to the database

of a pc-based system when installed within range of an amanTag receiver.

3 Tag usage

The tag can be attached as follows:

 On a keyring

 As an amulet

Once properly installed the Tag functions automatically providing the system with activate/response

data to locate its position. The user or equipment need do nothing else; just carry the Tag with the

item or person to be position located.

The command buttons on the tag have a variety of possible functions depending on the configuration

selections of the amanTag system administrator who will provide the appropriate functionality on tag

assignment.

Regulatory notices for Europe

Hereby, deister electronic declares that the radio equip-

ment type PSA 3 is in compliance with Directive

2014/53/EU.The full text of the EU declaration of conform-

ity is available at the following internet ad-

dress:https://go.deister.com/ce

Summary of content (2 pages)

PAGE 1
Regulatory notices for Europe PSA 3 tag quick start guide Also applies: Hereby, deister electronic declares that the radio equipment type PSA 3 is in compliance with Directive 2014/53/EU.The full text of the EU declaration of conformity is available at the following internet ad- dress:https://go.deister.com/ce ITA3 1 Package contents  amanTag PSA 3 tag  Quick start guide 2 Tag installation The tag must be installed by a trained amanTag system administrator.
PAGE 2
4 Panel Button 1 Button 2 LED red The panel of the tag consists of three buttons and and two LEDs. 5 LED-light of the tag  The red LED will flash to confirm when the button is pressed.  The red LED blinks during internal calibration after a battery change. For more information and your nearest point of contact, please refer to www.amantag.com Technical data are subject to change without notice at any time. The product psa-3_manual_en_896383_v200421_.docx conforms to CE rules. All rights reserved.