TPU 4030 PCB User Manual Art.
Content 1. Technical Data............................................................5 2. Mechanical Dimensions..............................................6 3. General Information...................................................6 4. Activating the Transponder........................................7 5. Acoustic Signal............................................................7 6. Battery Monitoring......................................................
Regulatory Notices Europe Hereby, deister electronic GmbH declares that this equipment - if used according to the instructions - is in compliance with the essential requirements and other relevant provisions of the RTTE Directive 1999/5/EC. A full declaration of conformity can be requested at: info@deister-gmbh.de Approved for use in all European countries. FCC Warning This device complies with Part 15 of the FCC rules.
© Copyright 2011 by deister electronic GmbH Disclaimer deister electronic GmbH is not able to supervise the observance of the instructions given in this manual as well as the conditions and methods used during installation, operation and maintenance of the electronic devices and components respectively.
1. Technical Data Dimensions: mm (inch) W x H x D 31.8 x 54.4 x 10 (1.25 x 2.14 x 0.41) Operating Temperature: °C (°F) 5 ... 50 (41 ... 122) Relative Humidity: 5 %...95 %, non-condensing Power Requirement: 1x CR 2450 Frequency: 8 kHz, 125 kHz, 433 MHz Reading Distance: in m (ft.) up to 10 (32.8) OTP: (e.g. Formats up to 64 Bit) Fixcode: (e.g.
2. Mechanical Dimensions All dimensions in mm [inch]. 3. General Information TPU 4030 is an active transponder, which was developed to be used in combination with Amantag Compact and / or PRX5 reader or ADA (Amantag deactivator). The transponder has three interfaces for communication with readers. • • • Receiving via 8,1 kHz Sending via 433 MHz Sending and receiving via125 kHz (passive modulation) Amantag Compact readers are using 8.1 kHz and 433 MHz frequencies.
4. Activating the Transponder For transportation, the transponders are set to transport mode. Before use. they must be activated. The activation is done by an Amantag compact reader. The DIP switch B6 needs to be set to ON position. Attention! Possibly, the field strength must be increased. Therefore, set DIP switch B1 to B4 to “ON” position. After configuration, the transponder should be placed close to the reader (it requires high power to wake up the transponder from transport mode).
Headquarters Germany: deister electronic GmbH Hermann-Bahlsen Str. 11 30890 Barsinghausen Tel.: +49 (0) 51 05 - 51 61 11 Fax: +49 (0) 51 05 - 51 62 17 info.de@deister.com www.deister.com France: deister electronic france 101 rue Pierre Semard 92320 Chatillon Tel.: +33 (0) 1 47 - 35 78 78 Fax: +33 (0) 1 47 - 35 92 59 info.fr@deister.com Great Britain: deister electronic (UK) Ltd. Stapleton Way, Enterprise Park Spalding, Lincolnshire PE11 3YQ Tel.: +44 (0) 1775 - 717100 Fax: +44 (0) 1775 - 717101 info.
