Integration Guide

August 22, 2022
5
1. Introduction
The Dejero Labs Inc EM9191 Embedded Module is a FirstNet-ready (B14 LTE) M.2 module and
provides 5G NR Sub-6G, 5G mmWave, 4G LTE advanced Pro, 3G (HSPA+, UMTS), and GNSS
connectivity for a wide range of devices and purposes, including business, personal, and
portable computing and communication devices, IoT devices, M2M applications and industrial
use cases.
EM9191 Embedded Modules are available in a variety of region-specific and
function-specific
SKUs, including both 5G NR Sub-6G and 5G mmWave-capable variants.
1.1. Accessories
A hardware development kit is available for M.2 modules. The kit contains hardware
components for evaluating and developing with the module, including:
 Development board
 Cables
 Antennas
 Other accessories
For over-the-air 5G and LTE testing, ensure that an appropriate antenna is being used.
1.2. Required Connectors
Table 1-1 describes the connectors used to integrate the EM9191 Embedded Module into your host
device.
Table 1-1 Required Host-Module Connectors
1
Connector Type
Description
RF cables — 5G NR Sub-6G/ LTE/GNSS
 Mate with M.2-spec connectors
 Four connector jacks (mate with I-PEX 20448-001R-081 or
equivalent)
RF cables — mmWave
 Eight connector jacks (mate with I-PEX 20955-001R-13 or
equivalent)
 Two cables for each mmWave antenna module (up to 8 cables
in total)
EDGE (67 pin)
 Slot B compatible — Per the M.2 standard (PCI Express M.2™
Specification Revision 3.0, Version 1.2), a generic 75-pin
position EDGE connector on the motherboard uses a
mechanical key to mate with the 67-pin notched module
connector.
 Manufacturers include LOTES (part #APCI0018-P001A01),
Kyocera, JAE, Tyco, and Longwell.
SIM  Industry-standard connector.
1. Manufacturers/part numbers are for reference only and are subject to change. Choose connectors that are appropriate
for your own design.