User's Guide

www.dejero.com
13 | Dejero EnGo 3x User Guide
Blue light flashing
once every 2
seconds for
approximately 30
seconds
The EnGo is off and connected to an external power source but the
battery is fully charged. After approximately 30 seconds, the blue light
stops flashing.
Blue light flashing
approximately
twice a second
The EnGo is on and the internal battery is below 20%. The EnGo is not
connected to an external power source so the battery is not charging.
Charge the EnGo using an auxiliary battery
Use the included power cord to connect to a D-Tap port on an auxiliary battery or the V-Mount
or Gold Mount battery plates to charge the EnGo.
1. Connect the power cord to the DC IN port on the side of the EnGo.
2. Perform one of the following actions:
● Connect the power cord directly to an auxiliary battery.
● Connect the power cord to the battery plate. Slide an auxiliary battery onto the battery
plate.
Note: When you connect an auxiliary battery to the EnGo, the battery both powers and charges
the EnGo (if the internal battery needs charging). Because it performs both functions, the battery
level in the auxiliary battery drains faster.
Starting the EnGo
1. On the front of the EnGo, press and hold for approximately one second.
While the transmitter turns on and establishes a network connection, start-up messages appear
on the Preview screen.
Using the EnGo
You can use the EnGo in one of the following operation modes:
● Live: Transmit live video over network blending of cellular, Wi-Fi, Ethernet, or satellite
connections to the Dejero receivers.
● Recording: Record video for later transmission. Use this mode when a live feed is not
required, or when bandwidth is limited or not available.