User's Guide

www.dejero.com
21 | Dejero EnGo 3x User Guide
d. Secure the sun shade to the hook-and-loop fastener strip on top of the cable storage
compartment. Ensure that the triangle flaps are captured underneath.
Note: To disassemble the sun shade, lift the hook-and-loop fasteners from the triangle flaps. Fold
the flaps up and close the front access panel.
Insert an HDMI cable into the EnGo backpack
By default, the backpack comes with the SDI cable already inserted. You can remove this cable
if you want to use an HDMI cable instead.
Note: If you only need to use an HDMI cable temporarily, feed the HDMI cable through the hook-
and-loop fastener opening on the side of the backpack. Remove the zip cords from around the
EnGo. Lift the EnGo and connect the HDMI cable to it. Replace the zip cords to secure the EnGo.
1. Use the four zippers at the top of the backpack to open the top compartment fully.
2. If the EnGo is in the backpack, remove it.
3. At the top of the backpack, use the zipper to open the cable storage compartment.