User's Guide

www.dejero.com
46 | Dejero EnGo 3x User Guide
The green meter shows the
audio data received from the
WayPoint receiver. It is heard
in the connected headset.
The blue meter shows the
microphone input audio data
from the connected headset.
By default, Intercom is enabled on the EnGo.
Enable Prompt Audio
You can enable Prompt Audio to send a low-latency audio feed from your audio input device to
your WayPoint receiver. You can still use IFB when Prompt Audio is enabled.
To use Prompt Audio, you must connect the audio interface device to the receiver. For more
information, visit support.dejero.com to read the Dejero Intercom Reference Guide.
Note: When you enable Prompt Audio, you cannot use the Intercom feature.
1. On the Preview screen, select .
2. Select Audio Comms.
3. Select Prompt Audio.
After you enable Prompt Audio, the transmitter sends one channel of audio to the receiver at a
lower latency. Along the left side of the Preview screen, the green audio meter with a white
background is the audio channel that is being sent.
Note: By default, the receiver sends the first channel of audio. If you want to send a different
channel of audio by default, contact Dejero Support.
Enable Intercom
By default, Intercom is enabled on the EnGo. If you enable Prompt Audio, you must enable
Intercom again before you can use it.
1. On the Preview screen, select .