User's Guide

www.dejero.com
57 | Dejero EnGo 3x User Guide
Start a transmission with the Wired Remote
After you connect the Wired Remote to the EnGo, you can use the remote to start a live
transmission.
Note: If a red light appears beside Ready on the Wired Remote, the EnGo is not ready to
transmit live. Use the Preview screen to review the network connection status and verify that
the EnGo is connected to a video source. Resolve any other warnings that appear on the
Preview screen. For more information, see "Troubleshooting" on page .
1. On the Wired Remote, ensure that a green light appears beside Ready.
2. On the remote, press and hold the Go Live button for three seconds.
After you press the Go Live button, on the Wired Remote, a green light beside Live flashes.
When the EnGo is transmitting live, the flashing green light beside Live turns solid green.
During this process and during the live transmission, the green light beside Ready continues to
appear.
Note: If a flashing yellow light appears beside Live, the EnGo is still transmitting live, but there is
a warning on the Preview screen. Review the Preview screen to resolve the issue.
Stop a transmission with the Wired Remote
1. On the Wired Remote, press and hold the Go Live button for three seconds.
About the Battery light states on the Wired Remote
The Battery light on the Wired Remote provides information about the charging or battery status
of the EnGo.
Light setting Description
No light The battery level is higher than 20%.
Solid yellow The battery level is lower than 20%.
Flashing red The battery level is lower than 5%. Connect the EnGo to a power source
immediately.