Technical data

caso MLG 23 Touch black 66
Take any packaging materials that are no longer required to
“Green Dot” recycling collection points for disposal.
Please note
► If possible, keep the original packaging for the device for the
duration of the guarantee period of the device, in order that
the device can be re-packaged properly in the event of a
guarantee claim.
14.5 Setup
14.5.1 Setup location requirements:
In order to ensure the safe and trouble-free operation of the
device, the setup location must fulfil the following prerequisites:
• The device must be set up on a firm, flat, horizontal and heat-
resistant surface with sufficient load-bearing capacity for the
oven and the maximum weight of the expected food that is to
be prepared in the oven.
• Choose the setup location in such a way that children cannot
reach any hot surfaces on the device.
• The device is not intended to be installed in a wall or a built-in
cupboard.
• Do not set up the device in a hot, wet or extremely damp
environment or near flammable material.
• The device requires an adequate flow of air in order to operate
correctly. Leave a clearance of 20 cm above the oven, 10 cm
around the back and 5 cm on both sides.
• Do not cover up any openings on the device and do not block
these off.
• Do not remove the device’s adjustable feet.
• The electrical socket must be easily accessible so that the
power lead can be disconnected easily, in the case of an
emergency.
• The installation and assembly of this device in non-stationary
setup locations (e.g. on ships) must be carried out by specialist
companies / electricians, provided they guarantee the
prerequisites for the safe use of this device.