Owner`s manual

Rev: April 2010
DEK® is exclusively distributed by GXi Outdoor Power LLC
3 of 12
Heavy Duty Power Equipment
Component Identification
Attaching the Chip Collection Bag

To attach the bag, place the opening of the bag completely
over the discharge chute and hook the metal grommets on
two wire hooks located near the base of the engine.
 Tighten the draw string securely.
Recoil Starter
The starter handle is located on the engine. Pull the starter
handle to start engine.
Chipper Chute
Allow twigs and small branches up to 4” in diameter to be fed
into the impeller for chipping. See Figure 6.
Chipper Funnel
Allow leaves and small branches up to 1/4” diameter to be fed
into the funnel for chipping and shredding.
Figure 6
Chipper Bag (shown in hardware bag below)
Collects shredded or chipped material fed through the chipper
chute or hopper assembly.
Lawn Tractor or ATV Hitch
To be used for towing by lawn tractors or ATVs at speeds
below 15 mph.
Discharge Chute
Chipped materials are discharged through this opening. It may
be left open or the chip collection bag (Chipper Bag) can be
attached to the chute.
Fuel Tank
Fill tank with regular unleaded fuel. Always leave about 1” of air
gap at the top of the tank for fuel expansion to prevent seepage
or spills.
Recoil
Starter
Chipper Funnel for depos-
iting leaves, grass, plant
debris only. Use the side
chute for branches.
Chipper Chute for
feeding branches up
to 4” in diameter.
Lawn tractor or ATV
trailer hitch (maximum
tow speed is 15 mph).
Discharge
Chute
Fuel Tank
Hardware bag, safety de-
vices and chip collection
bag
Clean out
and blade
access hatch
Serial #:
Stamped on engine block
between funnel and engine