User's Manual

P RODUCT M ANUAL CBDA D EKO 3178B D EKOLINK W IRELESS L TD .
Page ii Proprietary Data Pub. 300TC80031 Rev. 1.55
S AFETY W ARNINGS
Throughout this manual, important safety warnings are included to warn of possible hazards
to persons or equipment. A safety warning identifies a possible hazard and then describes
what may happen if the hazard is not avoided. The safety warnings – in the form of
Dangers, Warnings and Cautions must be followed at all times. These warnings are flagged
by the use of a warning icon, usually the triangular alert icon seen below. The exclamation
point within the triangular alert icon is intended to warn the operator or service personnel of
operation and maintenance from factors related to the product and its operating
environment, which could pose a safety hazard.
G ENERAL S AFETY W ARNINGS C ONCERNING U SE OF T HIS S YSTEM
Always observe standard safety precautions during installation, operation and maintenance
of this product. Only a qualified and authorized personnel should carry out adjustment,
maintenance or repairs to the components of this equipment.
D ANGER : E LECTRICAL S HOCK
This equipment is intended to be installed indoor. Wet conditions increase the potential for
receiving an electric shock when installing or using electrically powered equipment. To prevent
electrical shock when installing or modifying the system power wiring, disconnect the wiring at
the power source before working with un-insulated wires or terminals.
C AUTION : RF E XPOSURE
To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation distance of 35
cm or more should be maintained between the antenna of this device and persons during device
operation. To ensure compliance, operations at closer than this distance is not recommended. The
antenna used for this transmitter must not be co-located in conjunction with any other antenna or
transmitter.
W ARNING : E QUIPMENT MODIFICATIONS
Changes or modifications not expressly approved by Dekolink Wireless Ltd. could void the user’s
authority to operate the equipment