Installation Manual

IDEN REPEATER PRODUCT MANUAL DEKOLINK WIRELESS LTD.
1.5 SPECIFICATIONS
1.5.1 General
This paragraph provides the electrical, mechanical and environmental specifications
of the iDEN Repeater.
Note
Specifications are subject to change without notice.
1.5.2 Electrical Specifications
Parameters Downlink Uplink
Frequency Range 851 – 869 MHz 806 – 824MHz
Pass band Gain @Min
attenuation
90 dB typical 90 dB typical
Operating Bandwidth 18 MHz 18 MHz
Propagation Delay 5 µsec. 5 µsec.
Band Ripple ± 2 dB max ± 2 dB max
1 dB Bandwidth
Channel Rejection
18 MHz 18 MHz
20 dB Bandwidth 22 MHz 22 MHz
Noise Figure @max gain 7.0 dB 7.0 dB
Gain Control Setting (by
RMT software) – User
Defined
30 dB @1 dB/step 30 dB @1 dB/step
3
rd
Order Output
Intercept Point (IP3 out)
+56 dBm typical +45 dBm typical
Composite Output
Power
+36 dBm +1/-0 dB +24 dBm +1/-0 dB
Impedance Level 50 ohms 50 ohms
V.S.W.R In/Out 1.5: 1 max 1.5: 1 max
LO Leakage -13 dBm max. -13 dBm max.
Spurious in band -45 dBc typical -45 dBc typical
Spurious out of band -13 dBm max. -13 dBm max.
Power Supply 110 to 220 VAC
Maximum Consuming
Power
150 W
Page 2 Proprietary Data Pub. 307-2005 Rev. 1.0