Installation Manual

DEKOLINK WIRELESS LTD. PRODUCT MANUAL IDEN REPEATER
4.5 CABLES CONNECTION
4.5.1 General
Once the Repeater is installed, you are required to connect the cables from the
antennas and to plug to the power supply.
4.5.2 RF Cables Deployment
The RF interface between the Repeater and the antennas is supported by one (donor
and service) pair of N-type female connectors mounted on the Repeater bottom panel.
CAUTION
We recommend NOT to connect the antenna cables to the Repeater at this stage.
They shall be connected with RF Coaxial Jumpers at the activation step.
See Section
5.6.
Use the following procedures to connect the coaxial cables to the Repeater:
Connect the Donor antenna to the BASE port (N-type female connector) in
the Repeater lower connectors’ panel (see Figure 5)
•
•
•
Connect the Service antenna to the MOBILE port (N-type female connector)
in the Repeater lower connectors’ panel
Dress the exterior coaxial cables with insulation and holding tape (Type 3M
Rubber splicing tape) for environmental protection and to ensure longer
lifetime.
Note
The recommended coaxial cables are weather-resistant type, and therefore this
procedure is not necessary.
Figure 5: iDEN Repeater – Bottom Panel
Pub. 307-2005 Rev. 1.0 Proprietary Data Page 15