Installation Manual

IDEN REPEATER PRODUCT MANUAL DEKOLINK WIRELESS LTD.
4.5.3 Power Cable Connection
The repeater operates from a power source of 110V/220 VAC. The maximum
consumption power is 150W.
Danger: Electrical Shock
This equipment is usually installed outdoors. Wet conditions increase the
potential for receiving an electric shock when installing or using electrically
powered equipment. To prevent electrical shock when installing or modifying
the system power wiring, disconnect the wiring at the power source before
working with uninsulated wires or terminals.
CAUTION
Take all the necessary precautions against Electro-Static Discharge (ESD).
Proceed as follows:
Locate the AC power outlet, with at least a 6A slow blow fuse •
•
•
Connect the AC power cable from the AC power outlet to the POWER
connector in the Repeater. The repeater automatically turns on
(see Figure 5).
The green Led at the Repeater front panel turns on as an indication of power
supply on (there is no On/Off switch).
Page 16 Proprietary Data Pub. 307-2005 Rev. 1.0