Installation Manual

DEKOLINK WIRELESS LTD. PRODUCT MANUAL IDEN REPEATER
5. OPERATING INSTRUCTIONS
5.1 GENERAL
This section provides the operating instructions for the Digital Repeater. The
operating instructions require the use of the Repeater Management Tool (RMT)
software.
5.2 REPEATER MANAGEMENT TOOL (RMT)
5.2.1 General
The Repeater Management Tool (RMT) software supplied with the iDEN Repeater
provides full access to all control settings and monitoring capabilities. The RMT
software can be installed on Windows 95, Windows 98, Windows 2000, and
Windows XP operating systems.
This software tool is used to manage, monitor and control the repeater locally via a
serial connection or remotely through a modem. See the RMT User's Guide for more
information.
5.2.2 Software Installation
The RMT is activated by the RMT software package.
Install the RMT Software from the supplied CD to your laptop. For detailed
instructions, refer to the Repeater Management Tool User's Guide
P/N: 300MB40080.
•
•
•
•
•
The Repeater Management Tool icon will appear on your desktop.
5.3 LAPTOP LOCAL CONNECTION
To set up a local connection to a Laptop:
Open the Repeater door and identify the Controller.
Connect the Repeater to the Mains (if not already done) and wait for the
power LED on the Controller to begin flashing rapidly.
Connect an external serial cable (RS232) from the Laptop to the Controller
P3 (RS232) connector (see Figure 6). Make sure that the status led on the
Controller is blinking before you connect the cable.
Pub. 307-2005 Rev. 1.0 Proprietary Data Page 17