Installation Manual

IDEN REPEATER PRODUCT MANUAL DEKOLINK WIRELESS LTD.
5.6 REPEATER ACTIVATION PROCEDURES
To activate the iDEN Repeater parameters, proceed as follows:
1. Use the following procedures to connect the coaxial cables to the
Repeater:
Connect the Donor antenna to the BASE port (N-type female connector) in
the Repeater lower connectors panel (see Figure 5)
•
• Connect the Service antenna to the MOBILE port (N-type female
connector) in the Repeater lower connectors panel
2. Click on the Params. And Control tab. Set the options and check
data as described below.
3. Click on the Repeater Alarms tab. Check the status of the Leds -
All Leds should be colored green except the “Door Open” in red.
4. Test the performance of the system in the coverage area (drive test)
5. Disconnect the RS-232 cable from the Repeater and close the door
with the supplied key.
The Repeater is up and running.
Page 24 Proprietary Data Pub. 307-2005 Rev. 1.0