Installation Manual

DEKOLINK WIRELESS LTD. PRODUCT MANUAL IDEN REPEATER
6. MAINTENANCE AND TROUBLESHOOTING
6.1 GENERAL
This section provides the maintenance and troubleshooting procedures for the iDEN
Repeater.
6.2 PERIODIC MAINTENANCE
There is no periodic maintenance required for the iDEN Repeater. As long as it is
installed in a shaded area and not subject to extreme temperatures, it will provide long
term, carefree operation.
6.3 VISUAL INSPECTION
During normal operation, the POWER lamp is on. If the POWER lamp is off, check
the Mains power supply.
6.4 ALARMS AND TROUBLESHOOTING
6.4.1 Alarms
In case of general failure, the Repeater issues an alarm to warn for malfunction. This
alarm is issued from the Alarms connector (Open for alarm indication).
To display the Repeater Alarms screen:
1. Connect the Repeater to a Laptop – refer to paragraph 5.3 or
2. Connect the Repeater to a remote PC – refer to paragraph 5.4
3. Display the Repeater Alarms screen – refer to paragraph 5.5
4. In accordance with the lit LED, perform the troubleshooting
procedures as described below – refer to paragraph 6.4.2.
Figure 8: iDEN Repeater - Repeater Alarms Screen
Pub. 307-2005 Rev. 1.0 Proprietary Data Page 25