Installation Manual

DEKOLINK WIRELESS LTD. PRODUCT MANUAL IDEN REPEATER
APPENDIX D: MODEM INSTALLATION
(OPTION)
General
The iDEN Repeater is ready for connection of a serial, Hayes Compatible, AT
Command type modem with a phone number to allow connection in a circuit
switched network.
If you are using a modem with a SIM card, special settings (network or terminal
definitions) may be needed to allow data transmission.
Modem Installation
Perform the following steps to install a standard modem:
Connect the modem to the power supply.
Install the modem with a straight serial cable. This cable is usually supplied
with the modem. (See the tables below for the pinout description.)
Use a PC with the same terminal mode and bit rate as the default modem
baud rate. For example, 57,600, 19,200, 14,400 bps or other baud rate
depending on the modem default configuration.
Use the following commands:
AT S0=0 <ENTER>
AT+IPR=57600 <ENTER>
Change terminal baud rate to 57,600 bps if necessary.
Use the PC in terminal mode to save the new baud rate settings.
Use the following commands:
D AT&W1 <ENTER> (For some modems)
AT&W0 <ENTER> (For other modems)
Disconnect the serial cable from the PC and connect it to the Controller in
the Repeater.
Connect the antenna cable to the modem antenna port. (When testing the
unit in a laboratory, connect the modem to an external antenna) Refer to
Appendix C for more information.
Connect the modem to a Power Supply unit terminal.
Turn the Repeater AC power on.
Use a PC with a wireless or Plain Old Telephone System (POTS) modem
and the Dekolink RMT software to monitor the repeater.
Refer to the RMT User's Guide for more information on how to establish
remote connection with a repeater.
Pub. 307-2005 Rev. 1.0 Proprietary Data Page 31