User's Manual

PRODUCT MANUAL DEKO4078SD MULTI-CHANNEL SIGNAL BOOSTER DEKOLINK WIRELESS LTD.
P/N 300SC30031 Rev. 1.2 Proprietary Data Page 19
3.3 CONNECTING THE DONOR AND SERVICE ANTENNAS
CAUTION
DO NOT CONNECT THE ANTENNA CABLES TO THE BOOSTER BEFORE VERIFYING THE INSTALLATION
PARAMETERS - SPECIFICALLY THE ISOLATION BETWEEN THE ANTENNAS.
DO NOT POWER-ON THE BOOSTER (USING THE INTERNAL SWITCH) WITHOUT EITHER THE
ANTENNAS BEING CONNECTED OR THE ANTENNA CONNECTIONS TERMINATED WITH DUMMY LOADS.
Note: If the coaxial cables are NOT weather-resistant type, wrap the exterior coaxial
cables with insulation and holding tape (Type 3M Rubber splicing tape) for
environmental protection and to ensure longer lifetime.
To connect the antennas to the Power Amplifier
1. Install the antenna cables along their path to the Power Amplifier unit, and
connect them to the Antennas.
Note: Be sure to use low loss cables.
2. Connect the Donor antenna to the BASE port.
3. Connect the Service antenna to the MOBILE port.
4. Verify all RF connectors are tightened and the cables and antennas are secured
Figure 8. Power Amplifier and Antenna Connections