User's Manual

PRODUCT MANUAL DEKO4078SD MULTI-CHANNEL SIGNAL BOOSTER DEKOLINK WIRELESS LTD.
P/N 300SC30031 Rev. 1.2 Proprietary Data Page 3
SAFETY WARNINGS
Throughout this manual, important safety warnings are included to warn of possible
hazards to persons or equipment. A safety warning identifies a possible hazard and
then describes what may happen if the hazard is not avoided. The safety warnings
–
in the form of Dangers, Warnings and Cautions must be followed at all times. These
warnings are flagged by the use of a warning icon, usually the triangular alert icon
seen below. The exclamation point within the triangular alert icon is intended to warn
the operator or service personnel of operation and maintenance from factors related
to the product and its operating environment, which could pose a safety hazard.
GENERAL SAFETY WARNINGS CONCERNING USE OF THIS SYSTEM
Always observe standard safety precautions during installation, operation and
maintenance of this product. Only a qualified and authorized personnel should carry
out adjustment, maintenance or repairs to the components of this equipment.
DANGER: ELECTRICAL SHOCK
This equipment is intended to be installed indoor. Wet conditions increase the
potential for receiving an electric shock when installing or using electrically powered
equipment. To prevent electrical shock when installing or modifying the system
power wiring, disconnect the wiring at the power source before working with
un-insulated wires or terminals.
CAUTION: RF EXPOSURE
To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation
distance of 100 cm or more should be maintained between the antenna of this device
and persons during device operation.
To ensure compliance, operations at closer than this distance is not recommended. The
antenna used for this transmitter must not be co-located in conjunction with any other
antenna or transmitter.
WARNING: RESTRICTED ACCESS LOCATION
Access to the Dekolink 700/800 DMSB signal booster installation location is restricted
to SERVICE PERSONNEL and to USERS who have been instructed on the restrictions
and the required precautions to be taken.
ATTENTION: SYSTEM TESTING
All system tests should be performed with FM signals.