Installation Guide

OperationSuccess 1Beep
Enter/ExitSetUpMode 2Beeps
OperationFailure 3Beeps
LowBattery 5Beeps ←ReplaceallBatteries
MasterCode *00
SubCode1*01
SubCode2*02
SubCode3*03
SubCode4*04
SubCode5*05
SubCode6*06
SubCode7*07
SubCode8*08
SubCode9*09
TempCode10 *10
Pleaserecordyourcodesonthischartfor
yourrecords.
SK500USERINSTRUCTIONS
MyCodes
=StarKey
#=PoundKey
beep.ThiswillindicatethatUserMasterCodeandUserSub
Codeshavebeendeleted.
2)Returnto③,UserMasterCodesetuptoreprogramcodesusing
factorydefaultmastercode(111111)
1)Topreserveappearanceofdoorlock,wipe
downwithaclean
cloth.Donotusealcoholorsolventforcleaning.
2)UseAlkalinebatteriesonly.
⑤TEMPORARYUSERCODESETUP
1)Pressresetbuttontwicetoentersetupmode.
Note:Thiswillbeaonetimeusecodeonly.Aftercodeisenteredand
leverisengagedthelockwillrelockanddeletethiscode.
⑥DEFAULTSETUP
1)Pressandholdtheresetforupto3secondsuntilyouhearalong
Forexample:011234##.NowyournewUserCode1234forthe
01SubCodeposition
5)RepeatforSubCodepositions02through09
2)EnterUserMasterCodeand
thenpress#key
3)Aftersinglebeep,enter10andnewTemporarycode(4‐6digits)
Thenpress#keytoconfirmand#keyagaintoexit.
3)Aftersinglebeep,enter00
4)EnternewUserMastercode(4‐6Digits)andpress#keytoconfirm
5)Press#keyagaintoexit
Note:UserMasterCodeisnowusedtosetSubCodesandTemporary
Code.Ifallcodesaredeleted(see⑥),referbackto③toreset
PROGRAMMABLEUSERCODES
press#keytoconfirmand#keyagaintoexit.
allusercodes.
④SUBCODESETUP
2)Inputfactorydefaultmastercode(111111)andpress#key
1)Pressresetbuttontwicetoentersetupmode.
③USERMASTERCODESETUP
PROGRAMMING
①Thislockallowsone(1)Mastercode,nine(9)Subcodesandone(1)
⑦CAREANDMAINTENANCE
BeepSounds
TheSK500canbeprogrammedtoremainlockedatalltimesoritcanbe
programmedtoremainunlocked(passagemode)asneeded.The
interiorleverisalwaysopenallowingfreeexit.
UNLOCKING
Temporarycode.Theseareuserprogrammedcodes(see③
through⑤)
②Eachlockcomeswithanaccessemergencykey.Simplyremove
keyholecoverandunlockdoor.
1)Pressresetbuttontwicetoentersetmode.
2)EnterUserMasterCodeandthenpress#key
3)Aftersinglebeepenter
01andnewSubCode(4‐6digits)Then