Installation Guide

Right-handed door
Turn the tailpiece to a horizontal position
and insert it through the latch transmission
plate.
Left-handed door
Turn the to a vertical position
and insert it through the latch transmission
plate.
tailpiece
Install Latch and Outside Lock
Note the correct orientation
of the keyhole.
Select the appropriate length
for the based on the
thickness of the door.
Insert the at an angle into the base.
When the door is below 35 mm in thickness, use a plastic washer.
Entry Lock
tailpiece
tailpiece tailpiece
The should be in the
horizontal orientation.
tailpiece
Privacy & Lock
Turn the indicator to the green (unlocked) position.
Communicating
Select the appropriate length for the tailpiece based on the thickness
of the door.
Insert the tailpiece into the tailpiece base, turn in to the horizontal
orientation, and push it through the latch transmission plate.
Install the Inside Lock
Install Strike
(Unit：mm)
On the door frame, align the center of the strike with the center of the
latch bolt faceplate and trace its edges.
Drill holes as shown.
Chisel a 3 mm-deep indentation within the traces of the strike.
Place the strike flush with the door frame and secure it with screws.
Pull the handle upwards and turn the decorative cover to expose the
mounting holes.
Select the length of mounting screws based on the thickness of the door
and secure the inside lock body.
Turn the handle to check if it works properly.
Pull the handle upwards, turn the decorative cover, and then turn the
handle again to conceal mounting screws.
Pull the handle
upwards
Turn the cover
Conceal the
mounting screws
3 15
34
26
Ø22
34
67
45403531
55
折 線
34
22
52 67
Tailpiece
STRIKE TEMPLATE
TEMPLATE
Caution: Drill from both
faces of the door to
prevent door cracking.
Left-handed door
Make 25.4mm hole at center
of door edge.
Ø54mm
Fold on dotted line and fit on door edge
FOR BACKSET 60mm
Tailpiece
26