Installation Guide

US-DELANEY
Pocket Door Pull Latch Installation Instructions
3/2020-DELANEY
You will want to mark the
bottom of where you will want
the finger pull mounted (in our
case, we are mounting the pull
below the pocket door lock that
is installed). After you have
marked it, center your edgepull
on the door edge by using your
measuring tape if needed or the
below template. After you have
it all centered, map out with
your pencil and chisel where the
edge pull will sit on the floor.
A. Drill (1)
3
/4” and (2)
11
/16” holes as
shown on the layout. See hole depths
in the door detail illustration on the
next page.
B. Using the
1
/2” Chisel mortise about
1
/8” deep of the door wood making
sure not to go out side the lines. It’s
important to make sure your chisel is
sharp to achieve a clean look.
3/4"
3/8"
7/32"
ø 3/16"
3-7/16"
3-7/8"
7/32"
1-7/16"
1-23/32"
1/8"
5/16"
3/8"
PULL DETAIL
11/16" 5/16"
19/32"
1/2"
7/32"
Read this guide thoroughly before installation and follow the instructions. This product is designed for
lightweight interior doors. Do not use it on exterior or heavy metal doors.
Tools You Will Need
• Sharp Pencil
• Hammer
• Phillips Screwdriver
• Sharp
1
/
4
” Chisel
• Sharp
1
/
2
” Chisel
• Measuring Tape
•
11
/
16
” Drill or Spade Bit
•
3
/
4
” Drill or Spade Bit
1. Mark the Pull Layout on the Door 2. Drill the Holes & Chisel the Plate Mortise
∅
3
/4”
∅
11
/16”
1
/8”
Deep
A
B
MOUNTING
TEMPALTE
5/16"
3/8"
7/8"
2-3/32"
1"
DRILL
Hole
3/4"
DIA.
TOP
OF PULL
BOTTOM
OF PULL
DRILL
2 HOLES
11/16" Dia.
3/4"
3-7/16"
3-7/8"
C C