P TEMPLATE 35 1-9/16" 1-3/8" 40 Fit here on door edge 45 Mark Ø1" (25.4mm) hole at center of door edge. 2" 1-3/4" 51 ELECTRONIC DEADB O LT LOCK K 2 3 4 5 6 7 8 9 0 FOR BACKSET 60mm (2-3/8”) FOR BACKSET 70mm (2-3/4”) 1 USER MANUAL Ø54mm (2-1/8") Attention : Please do not use the "electronic" screwdriver for installation.
3. Install Latch KEYPAD ELECTRONIC DEADBOLT INSTALLATION INSTRUCTIONS a. Insert the latch and ensure it is paralleled to the door face. Mark the outline of the faceplate, then take out the latch. The BACKSET is the distance between the center of cross bore and edge bore of the door. Adjustable latch fits both BACKSET of 2-3/8” (60mm) and 2-3/4” (70mm). Please follow the steps shown below for BACKSET adjustment. b.
5. Install Keypad Assembly 8. Adjusting Turn Piece a. Ensure the latch bolt must be retracted. Turn the turn piece to left for 45 degrees when it's right-handed door. Turn the turn piece to right for 45 degrees when it's left handed door. b. Please refer to the diagram below for Cylinder Installation. Place deadbolt against keypad with tailpiece in horizontal position inserted through hub of the latch. Turn Piece c. Pass the IC wire under the latch to the interior side of the door.
■ Specification/ Function 1.Battery & Four AA(1.5V)Alkaline batteries. # 2.Low Battery 2-1 The batteries should be changed immediately once you see the LED flashes in red and hear constant beep sounds for about 10 seconds when press programming button. 2-2 All settings are retained in the memory and will not be affected even if the battery is completely dead. 2-3 The lock still can be operated by key even there is a power outage. ' " ! ( $ 3.
6.User Code 12.Unlock the door 6-1 The preset User Code is 1234. Please delete it and create your personal code when first time operation. 6-2 Up to 6 sets of User codes can be saved. 6-3 User Code is only for activating the lock, without programming function. 6-4 User Code is 4-10 digits in length. 6-5 User Code can be deleted or changed anytime if needed. 12-1 The door will be unlocked by key or pressing User Code on keypad from outside or by interior turn-piece.
■ Function Programming 17.Code Protection Function The operation will stop if entering unauthorized codes over 5 times. The System will re-operate again after 45 sec. Programming Code (PC) USER Code (UC) Detect Left / Right Hand Door Installation 18.Illumination Enter PC The LED Keypad will light up when pressing any button for ease of operating in the dark. 0 Remark : Please run the door-handing identifying process before function set up when first time installation or default setting restore.
Programming Code (PC) USER Code (UC) Set Autolock Time Delay Enter PC 6 Causes : The door-handing indentifying process is not yet complete. Solutions : Please execute the door-handing indentifying process as soon as the installation of the lockset is completed. Toggle Mute On/Off 7 Situation 2 After the installation of the lockset and batteries, no responses when you press any button (no sounds are emitted, and the back light does not work). Remark : Repeat same steps to turn beeper On/Off.
Situation 5 The functioning has been normal, but suddenly, the latch bolt locks up, and the turn piece inside cannot be rotated, not even with the key. Causes : The detection of latch bolt position is abnormal. Solutions : Please take out one battery first, then press any button on the front panel for electric discharge, and put the battery back next. The latch bolt will automatically re-detect its position subsequently.