Installation Guide

3/4"
1/4"
PREPARE THE DOOR
If using the Floor Guides, mortise a groove ¼” wide by ¾”
deep into the bottom center of each door’s edge.
INSTALL HANGERS
Position hangers on front center of stile (min. 2” from edge of doors,
equal on each side
). Cut a piece of cardboard 2” high and place
between the inner groove of the wheel and the top of the door to
correctly position the height of the hangers. Mark holes
& pre-drill
3/8” holes. Secure hangers.
INSTALL HEADER BOARD
Do not install track directly onto drywall. Install a 1” x 10”
Header Board above the door opening directly into studs.
Header board must be solid wood and measure at least the
full legth of the track or longer.
INSTALL STOPS & TRACK
4a. Insert Stops on either side of tracks, inside first & last holes.
4b. Position center of the first track by measuring up from the
floor (door height + 1 ¾”). Align Spacers with holes in track. Use
Lag Bolts to install track into wood header & wall. Use wrench to
secure screws through spacers.
4
1
3
4a
4b
BARN DOOR BYPASS KIT
ASSEMBLY INSTRUCTIONS
* Optional Connector Plate available
if connecting multiple tracks.
TOOLS REQUIRED
1/4”
3/8”
* Header Board and
Anchoring Screws not
included in kit.
Center to Stile or
minimum of 2"
2"
2
drill out
3/8"
Wall Spacer (8 or 12)
Floor Guide (2)
Left & Right Stops (2 ea.)
Track (2)
Hanger (4)
#8 Floor Screw (4)
¼ Floor Anchor (4)
Hanger Bolt
(8 or 12)
for Thicker Doors
Hanger Bolt
w/ Cap
(8 or 12)
Anti-Jump
Disc (4)
Allen Wrench (1)
5/16 Lag Bolt (4 or 6)
INCLUDED COMPONENTS
Bypass Bracket (4 OR 6)
Mounting
Lag Bolts
(8 or 12)
Bolts w/ Nuts
& Washers
(4 or 6)