Installation Guide

3/4"
1/4"
Wall Spacer (4 or 6)
Floor Guide (1)
Left & Right Stops (2)
Track (1)
Hanger (2)
#8 Floor Screw (2)
¼ Floor Anchor (2)
Anti-Jump Disc (2)
Allen Wrench (1)
5/16 Lag Bolt (4 or 6)
PREPARE THE DOOR
If using the Floor Guide, mortise a groove ¼” wide by ¾”
deep into the bottom center of door’s edge.
INSTALL HANGERS
Position hangers on top of door, measuring 4” to center of outside hole.
Secure hangers using screwdriver.
INSTALL HEADER BOARD
Do NOT install track directly onto drywall. Install a 1” x 4”
or 1” x 6” Header Board above the door opening directly
into studs. Header board must be solid wood and measure
at least the full legth of the track or longer.
4
2
1
3
4a
4b
INCLUDED
COMPONENTS
BARN DOOR HARDWARE KIT
3000 SERIES ASSEMBLY INSTRUCTIONS
* Optional Connector Plate available
if connecting multiple tracks.
TOOLS REQUIRED
1/4”
* Header Board and
Anchoring Screws not
included in kit.
4"
Mounting Screw (4)
INSTALL STOPS & TRACK
4a. Insert Stops on either side of track, inside the first & last hole.
4b. Position center of the track by measuring up from the floor
(door height + 1 ¾”). Align Spacers with holes in track. Use Lag
Bolts to install track into wood header & wall. Use wrench to
secure screws through spacers.