User's Manual

Program description
ALPRO ver 6.60/ Activity meter system
94118201.pdf2006-11-08
requires only one hour with of high activity
to set an alarm. For sensivity level 2, the
system requires two consecutive hours of
high activity. Sensitivity 3 requires 3
consecutive hours etc.
6:1:6:4:2 ACCURACY
ACCURACY
✽
+
99.996 %)
(
50
(
70
(60
99.998 %)
99.999 %)
+ +
+++
FILTER SETTINGS
The filter has three levels: 50 , 60 or 70.
Every level has a corresponding accuracy
expressed in %.
Default values are shown in the display, 50
corresponds to one plus sign, 60 to two plus
signs and 70 to three plus signs.
Each level can be adjusted upwards and
downwards by changing the activity level
value..
6:1:6:4:3 BREED STATE
FILTER SETTINGS
GIVE HIGH ACT ALARM:
✽
INSEMINATE -> PRG CHK
YES
CALVING -> HEAT YES
HEAT -> INSEMINATE
YES
INSEM
-> PRG CHK2
INSEMINATE ->DRY OFF
DRY OFF ->BUILD UP
BUILD UP -> CALVING
YES
YES
YES
YES
Set NO for the breeding states where
increased activity should NOT result in a
high activity alarm.
Default value for all states is YES
6:1:6:4:4 EXPECTED HEAT
FILTER SETTINGS
DAYS FROM HEAT:
2
✽
EXP. HEAT ACCURACY:
99.996 - 0.000 = 99.996 (50)
99.999 - 0.000 = 99.999 (70)
99.998 - 0.000 = 99.998 (60)
This display makes it possible to decrease
the accuracy for high activity alarms for up
to 4 days before and after the expected
heat date. Default value is 2 days.
When a lower accuracy is set, also a
smaller change in activity during the days
close to expected heat will give an high
activity alarm.
Note! Heat date must be reported in the
Breeding menu 1:3. Otherwise the ALPRO
system cannot calculate the expected heat
date!
52(60)