User's Manual

Start-up
ALPRO ver 6.60/ Activity meter system
94118201.pdf2006-11-08
• Press enter for the tag number to allocate
it.
• Choose another cow to go on allocating
activity tags.
REPLACE TAG NUMBER
COW NO: 21
REPLACE TAG NO: 91924
WITH TAG NO: 25631 NO
✽
If a cow already has a tag no, you will be
asked to confirm or reject the change.
• Toggle between NO and YES with any
numeral key. Press ENTER to confirm.
To set breeding attentions (remind
codes) for activity
BREEDING ATTENTION ON MPC
FIRST HEAT LED NO: 0
HEAT-> INSEM LED NO: 0
INSEM CHK LED NO: 0
PREG CHK ATT LED NO: 0
HIGH ACT LED NO: 0
COW IN WRONG GROUP
LED NO:
0
MPC DISPLAY MODE: COW AND YIELD
PULSATOR TYPE: EP100
HIGH VACUUM DELAY: 5.0 S
DRY OFF ATT
LED NO:
0
RELATIVE ACTIVITY
LED NO:
0
NO RF SENDING
LED NO:
0
Part of display 6:3:2:1
It is possible to set breeding attentions
(Remind codes) for activity parameters. The
parameters are: High activity, No RF
sending and Relative activity.
The breeding attentions are set on the
processor in menu 6:3:2:1 or in the MPC
unit. The LEDs on the MPC unit will then be
lit when a cow, reported with the attention in
question, enters that cow place.
The attentions are defined in menu
6:1:6:6:1 - 3 and follows the same pattern.
First the breeding attention is defined and
then max and min values are set to define
the time periods when reporting shall take
place. The sign "–" always means that the
parameter is ignored.
BREEDING ATTENTION ON MPC
HIGH ACT:
A.CT LEVEL >= +
AD
YS SINCE INSEM > -
✽
HOURS SINCE HIGH ACT < 20
HOURS SINCE HIGH ACT > -
DAYS IN MILK > 10
PREGNANT EXCLUDE
CULL EXCLUDE
6:1:6:6:1 HIGH ACTIVITY
The picture shows the default values.
High activity is defined by the Activity level;
i. e. one or more plus signs, two or three
plus signs or three plus signs during the last
24 hours.
The time period when the system shall look
for active cows is defined by:
20(60)