3dBi antenna professional installation instructions 1 Technical Parameters 3dbi antenna mainly apply to outdoor application scenarios， connect to outdoor AP 5GHz RF port by using a SMA type connector. Fig.1-1 3dbi antenna appearing diagram.
Chart 1-1 Technical Parameters Electrical Specifications AG-011420-0220-A0-0000 Model Frequency range 5.15~5.8G Impedance(Ω) 50Ω VSWR ≤2.0 Gain 3.
Below is the far-field pattern in horizontal direction and in vertical direction.
2 Safety Precautions Warning! Antenna installation is dangerous to some extent, please read over the below safety precautions before installation, so to avoid unnecessary injuries and deaths. Please set the antenna location far away from electricity such as power supply wire, street lamp or power supply box. Installer must pay attention not to touch the power supply wire, otherwise it may cause severe casualty. To choose a safe location where get far away from the power line or other cable.
location should be far away from the metal obstacles or wall shielding net, etc. 4 Proper locations to install 3dbi antenna. 3dbi antennas mainly apply to indoor ceiling such as halls, meeting room and corridor, at the mean time the antenna location be far away from the obstacles or metal objects such as central heating or metallic conduit. Generally speaking, the higher it be, the more area it will cover, so the more effective it will be.
5 Antenna Installation 3dbi antenna is mainly installed indoors, while other tools such as monkey wrench, cross screw driver and “-”type screw driver need to be prepared by yourself. 5.1 Installation Tools 1、monkey wrench 2、 “+”type screw driver and “-”type screw driver 5.2 RF cable requirements Generally we adopt the RF cable as short as possible. We suggest adopting high quality and low loss RF cable.
5.3 Antenna installing steps. Step 1. Attach the unit by a two screws on a wall and push it downwards until it clicks into position: Step 2.
6 Antenna Power-level Setting This document provides mandatory radio power-level settings that must be configured to ensure that your device complies with regulatory requirements in your region. 6.1 Radio power-level setting 1.LOGIN he default product address is 192.168.2.66.
2 Radio Power Tx Power（dBm）:3dBi 3 Different Frequency of the power setting 5150-5250MHZ:28dBi
5725-5850MHZ:28dBi
4 Select save and apply Click on the Save changes and apply.
