User Instructions

against lightning. The grounding wire must be attached to the grounding
stud on the unit.
If the unit is attached to a metal pole which is earth-grounded, no
further grounding is required.
Step 3. Connect the unit to the bracket together and tighten up with the
screws:
It is recommended not to tighten the unit’s mounting bracket details
until the alignment process of the antenna is complete.
Step 4. Attach the mounting bracket and the pole clamp with the bolts and
nuts. The clamp’s orientation will differ according the pole’s diameter
as displayed below:
Step 5. Power-up the unit.
It is recommended to use shielded Ethernet cable to reduce exposure of
the electromagnetic noise.
Step 6. Run the Antenna Alignment tool on Web management interface or on
OLED display and move the antenna in the horizontal and vertical planes
until the maximum RSSI visible on the Antenna Alignment graph is achieved.
Avoid standing directly in front of an operating antenna while
aligning.