User's Manual

User Manual 
deliberant Page21

Wireless – specify wireless mode (AP, Station, Station WDS, iPoll AP, iPoll Station), country,
SSID, IEEE mode, channel configuration, security and advanced radio settings.
Virtual AP – create and setup virtual AP (only in AP wireless mode).
Wireless ACL – access control by MAC address (only in AP and IPoll AP wireless modes).
Traffic shaping – download and upload traffic control.
Port forwarding – port forwarding rules (only in router network mode for AP and IPoll AP).
Static routes – static route rules (only in router network mode for AP and IPoll AP).
Services
WNMS – set WNMS server/collector URL allowing remote device configuration and monitoring.
System Alerts – set alerts which can be sent via SNMP Traps or/and SMTP notifications.
SNMP – SNMP service settings allowing remote device monitoring.
Clock/NTP – set device date manually or enable and configure NTP service.
SSH – control SSH connection.
HTTP – control HTTP connection.
Autodiscovery – control device autodiscovery function (only on Station, Station WDS and IPoll
Station wireless modes).
System
Administration – change password, reboot, restore factory default settings, backup/restore
configuration, troubleshooting file support.
Log – view device log, set system log forwarding settings.
LED – control operation of LEDs.
Firmware upgrade – upgrade device firmware.
Tools
Antenna alignment – measure received signal quality of the wireless link to align antenna in the
best direction.
Site Survey – information about other wireless networks in the local area.
Delayed reboot – setup delayed reboot for APC unit.
Ping – perform ping command.
Traceroute – perform graphical traceroute command.
Spectrum analyzer – check the signal strength on available channels.
ApplingandSavingConfigurationChanges
There are three general buttons located on the right top corner of the WEB GUI allowing managing
device configuration:
Apply – if pressed new configuration settings are applied instantly. It will take few seconds and
the device will be running with new settings. It should be noted that pressing Apply button
settings are not written to the permanent memory. Therefore, if the device is rebooted it will
start with old configuration settings.
Discard – if pressed parameter changes are discarded. It should be noted that if Apply or
Save&Apply is pressed it is not possible to discard changes.
Save&Apply – if pressed new configuration settings are applied instantly and written to the
permanent memory.
It is not required to press Apply or Save&Apply in every Web GUI tab. The device
remembers all changes made in every tab and after action button is used, all changes will
be applied.