User's Manual
User Manual
deliberant Page26
When device is configured to operate in Bridge mode, only device LAN settings should be configured
on the Network page:
Figure 14 – Bridge Mode Settings
IGMP snooping (only on AP or iPoll Bridge modes) – when enabled AP will passively snoop on IGMP
Report and Leave packets transferred between it's clients and IP Multicast hosts. It checks IGMP
packets passing through it, picks out the group registration information and generates internal L2
MAC forwarding table. Then it forwards multicast traffic using unicast packets directed according to
forwarding table.
Ethernet speed – configures the Ethernet link speed and the duplex mode of the Ethernet port.
Choose "auto" for automatic detection of link speed and duplex mode.
IPSettings
When assigning IP address make sure that the chosen IP address is unused and belongs
to the same IP subnet as your wired LAN, otherwise you will lose the connection to the
device from your current PC. If you enable the DHCP client, the browser will lose the
connection after saving, because the IP address assigned by the DHCP server is not
predictable.
Method – specify IP reception method: IP addresses can either be retrieved from a DHCP server or
configured manually:
Static IP – the IP address must be specified manually.
Dynamic IP – the IP address for this device will be assigned from the DHCP server. If
DHCP server is not available, the device will try to get an IP. If has no success, it will use pre-
configured fallback IP address. The fallback IP settings can be changed to custom values.
IP Address – specify IP address for device
Subnet mask – specify a subnet mask for device.
Default gateway – specify a gateway IP address for device.
DNS server – specify the Domain Naming Server.
Enable IP alias – specify the alternative IP address and the netmask for APC unit management.