User's Manual
User Manual
deliberant Page29
WANSettings
WAN network settings include settings related to the WAN interface. The access type of the WAN
interface can be configured as: Static IP, Dynamic IP, PPPoE client.
WAN mode – choose Static IP to specify IP settings for device WAN interface:
Figure 18 – Router WAN Settings: Static IP
MAC address – specify the clone MAC address if required. The ISPs registers the MAC address of
the router, and allows only that MAC address to connect to their network. In such case if there is need
to change hardware (router), you need to notify your ISP about MAC address change, or simply set
the router’s MAC address to the MAC address of the previously router/computer.
VLAN ID – specify the VLAN ID for traffic tagging on required radio interface [2-4095]. The Station
devices that associate using the particular SSID will be grouped into this VLAN.
WAN mode – choose Static IP to specify IP settings manually. This option needs parameters listed
below:
IP address – specify static IP address.
Subnet mask – specify a subnet mask.
Default gateway – specify a gateway.
DNS server – specify primary and/or secondary DNS server
Enable secondary IP – specify the alternative IP address and the netmask for APC unit management.