User's Manual
User Manual
deliberant Page30
WAN mode – choose Dynamic IP to enable DHCP client on the WAN side. This option does not
need any parameters:
Figure 19 – Routers WAN Settings: Dynamic IP
MAC address – specify the clone MAC address if required. The ISPs registers the MAC address of
the router, and allows only that MAC address to connect to their network. In such case if there is need
to change hardware (router), you need to notify your ISP about MAC address change, or simply set
the router’s MAC address to the MAC address of the previously router/computer.
VLAN ID – specify the VLAN ID for traffic tagging on required radio interface [2-4095]. The Station
devices that associate using the particular SSID will be grouped into this VLAN.
DHCP fallback setting – specify IP address, Subnet mask, Default gateway and optionally DNS
server for DHCP fallback. In case the APC unit will not get the IP address from the DHCP, the
specified fallback IP settings will be used.
Enable secondary IP – specify the alternative IP address and the netmask for APC unit management.