User's Manual
User Manual
deliberant Page31
WAN mode – choose PPPoE to configure WAN interface to connect to an ISP via a PPPoE:
Figure 20 – Routers WAN Settings: PPPoE client
MAC address – specify the clone MAC address if required. The ISPs registers the MAC address of
the router, and allows only that MAC address to connect to their network. In such case if there is need
to change hardware (router), you need to notify your ISP about MAC address change, or simply set
the router’s MAC address to the MAC address of the previously router/computer.
VLAN ID – specify the VLAN ID for traffic tagging on required radio interface [2-4095]. The Station
devices that associate using the particular SSID will be grouped into this VLAN.
User name – specify the user name for PPPoE.
Password – specify the password for PPPoE.
MTU – specify the MTU (Maximum Transmission Unit). The default value is 1500 bytes.
Reconnect mode – specify PPPoE reconnection mode:
Always on – PPPoE connection automatically starts without timeout. The router will keep trying
to bring up the connection if it is disconnected for some reason.
On demand – the PPPoE connection automatically starts when there is outbound traffic to the
Internet, and it automatically terminates if the connection is idle based on the value specified in
the Idle time [1-65535] setting.
DNS settings – allows selecting if automatically assigned or alternative DNS servers should be used.
Enable secondary IP – specify the alternative IP address and the netmask for APC unit management.
LANNetworkSettings
LAN network settings includes settings related to the LAN interface.