User's Manual
User Manual
deliberant Page57
Forward port – specify the port to which syslog messages will be forwarded [0-65535]. Default: 514.
Forward message level – specify the level of the message which will be sent to the remote syslog
server. The level determines the importance of the message and the volume of messages generated
by the device. The levels are in order of increasing importance
[emergency/alert/critical/error/warning/notice/information/debug]. Default: information.
Forward backup – select to enable remote syslog logging backup.
Backup server – specify the backup host IP address or hostname where syslog messages will be
send to.
Backup port – specify the port to which syslog messages will be forwarded [0-65535]. Default: 514.
LEDControl
The APC is equipped with 6 LEDs: power, LAN and 4 Signal LEDs that indicates the signal strength
of current connection. The signal level is classified into 4 levels, thus corresponding 4 LEDs switches
on as soon as indicated threshold is reached.
Figure 63 – Device LED Control
LAN LED – select to enable LAN LED. The red LED will be blinking on LAN activity, off – no LAN
connection.
Power LED – select to enable Power LED. The steady red LED when power is on, off – no power.
Signal LED – select to enable signal strength indication LEDs:
Thresholds – specify the RSSI threshold at which corresponding LED will switch on.
The Signal LEDs are working only when the connection is established. Therefore, please
make sure all wireless settings are correct and the connection is established.