User's Manual

FCC Caution:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in
portable exposure condition without restriction.
FCC ID:2A4Q7BN59-01298H
123
VOL CH
CH(Channel)
Move the button up or down
to change the channel.To
see the Guide screen,press
the button.
VOL(Volume)
Move the button up or down
to adjust the volume To mute
the sound.press the button.
When pressed for 1 second
or more,the Accessibility
Shortcuts appears.
Smart hub
Directonal pad
(up/down/left/right)
4 Color buttons
Use these colored buttons to access
additional options specific to the
feature in use.
Voice Interaction
Power
Number pad
Return
Pairing the TV to
the Smart Remote
When you turn on the TV first time,
the Smart Remote pairs to the TV
automatically.If the Smart Remote
does not pair to the TV automatically,
Point it at the remote control sensor
of the TV,and then press and hold the
buttons labeled and as shown in
the figure on the left simultaneously
for 3 seconds or more.
Select
USER MANUAL