Instruction manual

INSTALLATION
The installation must be carried out by a suitably qualified
person, in accordance with the current version of the
following.
o UK Regulations and Safety Standards or their European Norm
Replacements.
o Building Regulations (issued by the Department of the
Environment).
o Building Standards (issued by the Scottish Development
Department).
o IEE Wiring Regulations.
o Electricity At Work Regulations.
Before connecting the appliance, make sure that the supply voltage marked
on the Rating Plate corresponds with your mains supply voltage.
WARNING: THIS APPLIANCE MUST BE EARTHED.
o This appliance should be wired into a 13 A double pole switched fused
spur outlet, having 3 mm contact separation and placed in an easily
accessible position adjacent to the appliance. The spur outlet must still
be accessible even when your oven is located in its housing to enable
the appliance to be disconnected from the mains supply.
o T
o
connect the oven power cord, loosen and remove the cover on the
terminal block, in order to gain access to the contacts inside. Make the
connection, securing the cord in place with the cable clamp provided
and then immediately close the terminal block cover again.
o If you have to change the oven power cord, the earthing
(yellow/green) conductor must always be 10 mm longer than the line
conductors.
o Care must be taken to ensure that the temperature of the mains
supply cable does not exceed 50°C.
o If the mains supply cable is damaged, then it must be replaced by an
appropriate replacement which can be obtained from the Spares
Department.
18