Installation Guide Wyse® VX0L and VX0LE Thin Clients 1-GB RAM Upgrade Option Kit Issue: 022808 PN: 883884-07L Rev.
ii Copyright Notice © 2008, Wyse Technology Inc. All rights reserved. This manual and the software and firmware described in it are copyrighted. You may not reproduce, transmit, transcribe, store in a retrieval system, or translate into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, any part of this publication without express written permission.
iii Thin Client Requirements Compliance FCC Compliance Model VX0 thin clients meet Class B requirements. IEC/EN Compliance Model VX0 thin client meet Class B requirements. Canadian DOC Notices Refer to the previous section, "Thin Client Requirements Compliance," to find out to which Thin Client model each of the statements below refers.
Contents Installation Guide Regulatory Notices Contents About This Guide 1 Before You Begin 1 Kit Warranty 1 What’s in the Kit 1 Required Tools and Materials 1 Wyse Technical Support 2 Related Online Resources Available at Wyse Installing the Option Kit 2 Verifying the Thin Client’s Operation 4 2
Installation Guide Wyse® VX0L and VX0LE Thin Clients 1-GB RAM Upgrade Option Kit About This Guide This guide describes how to install the 1-GB RAM Upgrade Option Kit in a Wyse VX0L or VX0LE thin client. This guide is intended for users of Wyse VX0L/LE thin clients. Before You Begin This section provides information about kit warranty, kit contents, the tools needed, and accessing Technical Support and related online resources.
2 Warning The RAM module may be susceptible to damage by Electro-Static Discharge (ESD). All industry-standard cautions should be followed to avoid ESD. Caution Follow all precautions listed in the Quick-Start Guide that came with your thin client for disconnecting and reconnecting the thin client. Wyse Technical Support To access Wyse technical resources, visit http://support.wyse.com.
3 4. Remove the top cover from the thin client by inserting the tip of a small Flat-Edge Screwdriver just inside the edge of the lock receptacle to make contact with the metal liner that lines the opening. Apply pressure inward and downward on the metal liner while pulling up on the plastic housing until it releases. 5. Carefully remove the existing module from the socket, noting where the connector of the module is located.
4 7. To install the 1-GB RAM module, peel off the colored textured strip from the thermal pad, and then with its label facing down, insert the new module into the location of the original module at the same angle. Press the module’s raised edge downward until the latches snap back in place. Warning The RAM module may be susceptible to damage by Electro-Static Discharge (ESD). All industry-standard cautions should be followed to avoid ESD. 8. Replace the top cover and attach the vertical foot. 9.
5 2. From the desktop, click Start | About to open the Client Information window. 3. Verify that the MAC address and Serial Number matches the serial number and MAC address on the thin client. 4. Verify that the RAM Configuration is approximately 1008 MB. 5. Click OK to close the Client Information window. The thin client is ready for operation and setup by the Administrator.
Installation Guide Wyse® VX0L and VX0LE Thin Clients: 1-GB RAM Upgrade Option Kit Issue: 022808 Written and published by: Wyse Technology Inc.
