Installation guide

Installing Rx0LE Flash and RAM 11
Step 3: Install the Rx0LE RAM Module
Warning
RAM modules may be susceptible to damage by Electro-Static Discharge
(ESD). All industry-standard cautions should be followed to avoid ESD.
Before you remove or install a module, touch any metal part of the chassis
and keep that contact with the chassis during the installation process.
1. Unlock the two locking clamps at either side of the RAM module by pushing in the
direction of the arrows as shown in Figure 10.
2. Remove the RAM module.
Figure 10 Removing the existing RAM module
3. Insert the new RAM module into the connector of the original RAM module.
4. Carefully press down on the RAM module until the locking clamps lock it into place.
Step 4: Reassemble the Rx0LE Thin Client
1. Replace the left side cover in the reverse order as described in "Step 1: Remove the
Rx0LE Thin Client Left Side Cover."
2. Attach the vertical foot.
3. Reconnect the video display, keyboard, mouse, network cable, and power adapter to
the thin client before connecting to an electrical outlet.
Caution
Do not turn on the thin client. The thin client is ready to re-image, however
the flash module does not contain an operating system. Turning on power to
your thin client without firmware will display the error message “NO
OPERATING SYSTEM FOUND.”
What’s Next
Continue with "Installing WES2009 Firmware."