Installation guide

4 Chapter 2
Procedures
Step 1: Remove the Rx0L Thin Client Left Side Cover
Caution
Follow all precautions listed in the Quick-Start Guide that came with your thin
client for disconnecting and reconnecting the thin client.
1. Perform a proper shutdown of the thin client by closing all files and ending your
session, and then press the power button to turn off the thin client.
2. Unplug the power cord and power adapter, remove all of the cables from the rear of the
thin client, and then detach the vertical foot.
3. Position the thin client horizontally, and then remove the screws from the top and
bottom of the thin client using a small Phillips screwdriver as shown in Figure 2.
Figure 2 Removing the top and bottom screws
4. Slide the left side cover toward the rear of the device and remove it to expose the main
board as shown in Figure 3. Notice that the rear of the thin client is positioned at the
bottom of the photo.
Figure 3 Left side cover removed to expose the main board