Service Manual
Table Of Contents
- Precision 3460 Small Form Factor Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Precision 3460 Small Form Factor
- Side cover
- Front bezel
- Hard drive
- Hard-drive and optical-drive bracket
- M.2 solid-state drive
- Removing the M.2 2230 solid-state drive (slot-1)
- Installing the M.2 2230 solid-state drive (slot-1)
- Removing the M.2 2230 solid-state drive (slot-2)
- Installing the M.2 2230 solid-state drive (slot-2)
- Removing the M.2 2280 solid-state drive (slot-1)
- Installing the M.2 2280 solid-state drive (slot-1)
- Removing the M.2 2280 solid-state drive (slot-3)
- Installing the M.2 2280 solid-state drive (slot-3)
- WLAN card
- WLAN antenna
- Coin-cell battery
- Memory
- Hard-drive and optical-drive supporting bracket
- Expansion card
- Optical drive
- Speakers
- Processor fan and heat-sink assembly
- Processor
- Power-supply unit
- Fan
- Power button
- Intrusion switch
- SD-card reader
- Optional I/O modules (PS2/Serial)
- System board
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Remove the antenna cables from the routing guides on the chassis.
2. Remove the two (M2x3) screws that secures the WLAN antenna to the chassis.
3. Lift the WLAN antenna off the chassis.
Installing the WLAN antenna
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the WLAN antenna and provides a visual representation of the installation
procedure.
36
Removing and installing components