Service Manual
Table Of Contents
- Precision 3460 Small Form Factor Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Precision 3460 Small Form Factor
- Side cover
- Front bezel
- Hard drive
- Hard-drive and optical-drive bracket
- M.2 solid-state drive
- Removing the M.2 2230 solid-state drive (slot-1)
- Installing the M.2 2230 solid-state drive (slot-1)
- Removing the M.2 2230 solid-state drive (slot-2)
- Installing the M.2 2230 solid-state drive (slot-2)
- Removing the M.2 2280 solid-state drive (slot-1)
- Installing the M.2 2280 solid-state drive (slot-1)
- Removing the M.2 2280 solid-state drive (slot-3)
- Installing the M.2 2280 solid-state drive (slot-3)
- WLAN card
- WLAN antenna
- Coin-cell battery
- Memory
- Hard-drive and optical-drive supporting bracket
- Expansion card
- Optical drive
- Speakers
- Processor fan and heat-sink assembly
- Processor
- Power-supply unit
- Fan
- Power button
- Intrusion switch
- SD-card reader
- Optional I/O modules (PS2/Serial)
- System board
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
Steps
1. Slide the power-supply unit into the chassis until the securing tab snaps into position.
2. Replace the three screws (#6-32) to secure the power-supply unit to the chassis.
3. Route the power cable through the routing guides on the chassis and connect the power cables to their respective
connectors on the system board.
Next steps
1. Install the hard-drive and optical-drive cage.
2. Install the 3.5-inch hard-drive.
3. Install the 2.5-inch hard-drive.
4. Install the front bezel.
5. Install the side cover.
6. Follow the procedure in after working inside your computerafter working inside your computer.
60
Removing and installing components