Service Manual
Table Of Contents
- OptiPlex 5000 Small Form Factor Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Customer Replaceable Units (CRU) and Field Replaceable Units (FRU) list
- Major components of OptiPlex 5000 Small Form Factor
- Side cover
- Front bezel
- Intrusion switch
- Hard drive
- Hard-drive and optical-drive bracket
- Optical drive
- Solid-state drive
- Hard-drive and optical-drive supporting bracket
- SD-card reader
- Coin-cell battery
- Power button
- WLAN card
- WLAN antenna
- WLAN antennas (External)
- Memory
- Processor fan and heat-sink assembly
- Voltage regulator heat sink
- Processor
- Expansion card
- Optional I/O modules (PS2/Serial)
- Optional I/O modules (VGA/HDMI/DP/USB Type-C)
- Chassis fan
- Speakers
- Power-supply unit
- System board
- Drivers and downloads
- Getting help and contacting Dell
Next steps
1. Install the 3.5-inch hard-drive.
2. Install the 2.5-inch hard-drive.
3. Install the front bezel.
4. Install the side cover.
5. Follow the procedure in after working inside your computer.
Optical drive
Removing the optical drive
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch hard-drive.
5. Remove the 3.5-inch hard-drive.
6. Remove the hard-drive and optical-drive bracket.
About this task
The following images show the slim optical-drive and provide a visual representation of the removal procedure.
Removing and installing components
31