Service Manual
Table Of Contents
- OptiPlex 5000 Small Form Factor Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Customer Replaceable Units (CRU) and Field Replaceable Units (FRU) list
- Major components of OptiPlex 5000 Small Form Factor
- Side cover
- Front bezel
- Intrusion switch
- Hard drive
- Hard-drive and optical-drive bracket
- Optical drive
- Solid-state drive
- Hard-drive and optical-drive supporting bracket
- SD-card reader
- Coin-cell battery
- Power button
- WLAN card
- WLAN antenna
- WLAN antennas (External)
- Memory
- Processor fan and heat-sink assembly
- Voltage regulator heat sink
- Processor
- Expansion card
- Optional I/O modules (PS2/Serial)
- Optional I/O modules (VGA/HDMI/DP/USB Type-C)
- Chassis fan
- Speakers
- Power-supply unit
- System board
- Drivers and downloads
- Getting help and contacting Dell
Steps
1. Align and lower the system board into the system until the stand-off points at the back of the system board align with those
on the chassis.
2. Replace the four (#6-32) screws to secure the system board to the chassis.
3. Route and connect all the cables that you disconnected from the system board.
4. Place and align the front I/O-bracket with I/O slot on the chassis.
5. Replace the screw (#6-32) that secures the front I/O-bracket to the chassis.
Next steps
1. Install the processor.
2. Install the heat-sink and fan assembly.
3. Install the WLAN card.
4. Install the solid-state drive.
5. Install the memory modules.
6. Install the expansion card.
7. Install the hard-drive and optical-drive cage.
8. Install the 3.5-inch hard-drive.
9. Install the 2.5-inch hard-drive.
10. Install the front bezel.
11. Install the side cover.
12. Follow the procedure in after working inside your computer.
Removing and installing components
87