Deployment Guide

Deployment Guide 45
7 Click Next .
The
Specify Network Interface Usage window appears, displaying a list of
cluster-wide network interfaces.
8 In the Interface Type drop-down menus, configure the public Interface
Ty p e
as Public and the private Interface Type as Private (if required) by
selecting the
Interface Name and clicking Edit . Select the correct
Interface Type and click OK.
9 Click Next .
10 In the Cluster Configuration Storage screen, perform the following steps
for the OCR disk:
a Locate the 20 MB partition that you created in the subsection
"Preparing the OCR and Voting Disks for Clusterware" on page 30.
b Select the partition and click Edit .
c In the Specify Disk Configuration window, select Place OCR
(Primary) on this partition
and click OK .
11 In the Cluster Configure Storage screen , perform the following steps for
the Voting disk:
a Locate a 50 MB partition that you created in the subsection "Preparing
the OCR and Voting Disks for Clusterware" on page 30.
b Select the partition and click Edit .
c In the Specify Disk Configuration window, select Place Voting Disk
on this partition
and click OK .
12 Click Next .
13 Ignore the warning messages and click OK .
14 In the Summary window, click Install to start the installation procedure.
NOTE: If a failure occurs in the Configuration Assistant window, perform the
following steps and see "Troubleshooting" on page 55 and "Working Around
Clusterware Installation Failure" on page 55.
The Install window appears, displaying an installation progression bar.
The
Configuration Assistant window appears and the OUI runs a series of
configuration tools.
The
End of Installation window appears.