Deployment Guide
Deployment Guide 37
%SystemDrive%\Oracle_patch\setup.exe
where
%SystemDrive%
is the drive on which you unzipped the Oracle
patchset.
2
In the
Welcome
screen, click
Next
.
3
In the
Specify home details
window, select
name
as
OraCr10g_home
from
the drop down list and click
Next
.
4
In the
Specify Hardware Cluster Installation Mode
window, click
Next
.
5
In the
Product-Specific Prerequisite Checks
window, click
Next
.
6
In the
Summary
window, click
Install
.
7
In the
End of Installation
window, perform all the steps listed in the
Summary
window. Do not perform the step instructing you to stop the
Oracle services—you should have already completed that step
before
you
began installing the patchset as mentioned in "Before You Begin" on
page 36.
8
On the
End of Installation
window, click
Exit
.
9
Click
Yes
to exit from the OUI.
Installing Patchset 10.2.0.4 for Oracle 10
g
Database
NOTE: Before you install the patchset, ensure that all the Oracle services are
running.
Complete the following procedures before creating a listener and a seed
database.
Installing the Patchset
NOTE: You must install the patchset software from the node where the RAC 10
g
R2
software was installed. If this node is not the one where you are running the OUI,
exit and install the patchset from that node.
1
Start the OUI located in the unzipped area of the patchset. For example:
%SystemDrive%\Oracle_patch\setup.exe
where
%SystemDrive%
is the drive on which you unzipped the Oracle
patchset.
2
In the
Welcome
screen, click
Next
.