Owner`s manual

Installing the Display Assembly

1. Install the display assembly and close the display.

2. Flip the computer chassis.

3. Install the display hinges in their slots.

4. Tighten the screws to secure the hinges.

5. Route the cables through the rubber gasket.

6. Install the hinge cover.

7. Tighten the screws to secure the hinge cover.

8. Install the eDP connector and place the bracket in its slot.

9. Tighten the screws to secure the eDP connector to the system board.

10. Route the cable through the routing channels.

11. Install:

a. heatsink

b. WWAN

c. WLAN

d. card bracket

e. Connect the battery cable to battery board.

f. hard drive

g. MEMS board

h. USH board

i. GPS module

j. docking board

k. bottom cover

l. battery

12. Follow the procedures in After Working Inside Your computer.

Removing the System Board

1. Follow the procedures in Before Working Inside Your Computer.

2. Remove:

a. battery

b. bottom cover

c. docking board

d. GPS module