User guide
Table Of Contents
- Before Beginning
- Setting Up Printer (Printer Setup)
- Using Your Printer
- Print Media Guidelines
- Loading Print Media
- Operator Panel
- Printing
- Know Your Printer
- Maintaining Your Printer
- Troubleshooting
- Troubleshooting
- Basic Printer Problems
- Display Problems
- Printing Problems
- Print Quality Problems
- The output is too light
- Toner smears or print comes off/Stain on back side
- Random spots/Blurred images
- The entire output is blank
- Streaks appear on the output
- Pitched color dots
- Vertical blanks
- Mottle
- Ghosting
- Fog
- Bead-Carry-Out (BCO)
- Auger mark
- Wrinkled/Stained paper
- The top margins is incorrect
- Color registration is out of alignment
- Protrudent / Bumpy paper
- Noise
- Jam
- Other Problems
- Contacting Service
- Troubleshooting
- Appendix
- Index
Loading Print Media 65
NOTICE: Never use envelopes with windows, or coated linings. These lead to
paper jams and can cause damage to the printer.
NOTE: If you do not load envelopes in the MPF right after they have been removed
from the packaging, they may bulge. To avoid jams, flatten them as shown below
when loading them in the MPF.
NOTE: If envelopes are still not fed correctly, add some bending to the flap of the
envelopes as shown in the following illustration.
The amount of the bending shall be 5mm (0.20 inches) or less.