User guide

Operator Panel 77
Printing a Device Settings Page
Press and hold the (Start) button when the Ready/Data indicator lights
(ready status) until the Ready/Data indicator blinks.
Resetting Defaults
After executing this function and rebooting the printer, all the menu
parameters are reset to their default values.
1
Turn off the printer.
2 Open the rear cover.
3 While holding down the (Start) and the (Cancel) buttons at the
same time, turn on the printer.
4 After the Orange LED on the Ready/Data indicators go out, release the
(Start)
and (Cancel) buttons.
5 Close the rear cover.
• Initializes the non-volatile memory (NVM).
CAUTION: Never attempt to turn off the printer. The printer will cease to
function.
The printer restarts automatically to apply the settings and prints the
printer settings and device settings pages.
6 Check if the factory settings are restored by referring to the Printer
Settings and Device Settings pages.
- - - An error occurred while
downloading the firmware.
Turn off the printer, and then
on.
1 2 3 4 5 7 8 Cause/Remedy
Jam Toner Error Ready/
Data
Start Manual
Duplex
Load
Paper
YMC K