Owner`s manual

OM_Book.book Page 56 Tuesday, September 25, 2012 2:30 PM
8 Gently lift the palm-rest assembly to a 90-degree angle and then release
the palm-rest assembly off the display assembly.
3
1
2
1 palm-rest assembly 2 screws (4)
3 display hinges (2)
Replacing the Display Assembly
1 Slide and place the palm-rest assembly over the display assembly.
2 Press down on the display hinges and ensure that the screw holes on the
display hinges align with the screw holes on the palm-rest assembly.
3 Replace the screws that secure the display assembly to the
palm-rest assembly.
4 Route the mini-card cables through the routing guides.
5 Slide the touchpad cable into the system-board connector and press down
on the connector latch to secure the keyboard cable.
Display Assembly 56